BENRO TRIPOD TRAVEL VIDEO CARBON AERO 6 PRO REF. C3883TS6PRO

Benro C3883 Back Folding Carbon Fiber Travel Tripod with S6Pro Fluid Video Head

The Benro S6Pro Fluid Video Head C3883 Back Foldable Carbon Fiber Travel Tripod features a highly compact travel tripod that can be converted to a monopod, and a compact fluid head with a 65mm flat base that allows move the head directly to most of the sliders. jibs and other support equipment. The head supports loads up to 13.2 pounds and offers 5 + 0 steps of counterweight. The tripod's carbon fiber design ensures better vibration absorption and corrosion resistance from salt water, something to keep in mind if shooting on the beach near water. Carbon fiber is also lighter than aluminum.
The tripod has a center column with a leveling adapter at the end that allows you to adjust the angle of the fluid head without having to readjust the tripod legs. The combination of the back fold design and the center column allows the tripod to have a maximum height of 72 "(with the head attached) while it can be folded to a very compact size. In addition, the tripod legs can be extended widely to provide a low angle minimum height of only 13.4 "(also with attached head). With rubber feet and spikes underneath, the tripod can be used on virtually any surface. To make it a monopod, the center column is used as the central component. One of the tripod legs unscrews from the tripod and attaches to the center column, and together the two form a fully functional monopod.
The S6Pro head features continuous pan and tilt drag and has independent pan and tilt locks. The tilt range is a wide + 90 / -75 °, and the swivel range is a full 360 °. Some parts of the head are made of magnesium and other parts of aluminum. Virtually the entire head, including its knobs, is made of robust yet lightweight metal.
A bread stick is included that can be attached to a rosette adapter on the left or right side of the head, for right- or left-handed users. A camera plate is included that can be adjusted forward / backward to allow you to find the optimal balance for your camera. A safety lock on the plate ensures that once mounted, the plate will not come off if you move it too far in either direction. Two camera screws (1/4 "-20 and 3/8" -16) are supplied that can be stored under the camera plate in the head itself, in dedicated slots. For attaching accessories, there is a 1/4 "-20 threaded hole on each side of the head to which you can secure the link arms.
S6Pro fluid head
13.2 lb payload
65mm flat base with 3/8 "-16 thread
Can also be mounted directly to most sliders, jibs, and monopods
5 + 0 counterweight steps
Continuous pan and tilt drag
Independent pan and tilt locks
+ 90 / -75 ° tilt range
360 ° swivel range
Made of magnesium and aluminum.
Rosette adapters on the left and right side to attach the included pan bar
Sliding camera plate with safety lock
1/4 "-20 and 3/8" -16 camera screws included and can be stored in dedicated spaces on top of the head, under the camera plate
Two 1/4 "-20 tapped holes for accessories
C3883 Tripod
Backward folding travel tripod with center column and leveling adapter
Convertible into a monopod with one of the tripod legs unscrewed and secured to the center column
72 "maximum height with attached S6Pro
Low angle minimum height of 13.4 "
Rubber feet and spikes
Swivel leg locks
Carbon fiber construction